Marantz SR4300 manual Remote Control Range, Loading Batteries

ENGLISH

⁄6Numeric buttons 1 to 9 / Surround mode buttons

Numeric buttons (1 - 9)

These buttons are used to enter figures in the selection of a tuner preset station and station name preset or to set select a CD track number, etc.

The functions of these buttons are dependent on the function button selected.

Surround mode buttons (when AMP mode is selected)

These buttons are also used to select the surround mode.

Note:

•The M-CH ST button is used to 6-stereo mode.

⁄70 / A/D button

0 button

This button is used to enter the number “0”

A/D button (when AMP mode is selected)

This is used to switch between the analog and digital inputs.

⁄8MENU button and MENU OFF button

MENU button is used to enter the menu functions. Use the menu functions to setup SR4300. MENU OFF button is used to return original display from menu functions.

⁄9Cursor buttons (, , , , OK)

Use these button when operating the SETUP MENU functions.

:Moves the cursor left : Moves the cursor right : Moves the cursor up : Moves the cursor down

OK : Enters to the SETUP MENU or Confirms the setting

¤0MAIN VOLUME (Up) / (Down) buttons

Adjusts the overall sound level. The front, surround, center and subwoofer channel volumes controlled by these buttons simultaneously.

¤1CONTROL buttons

These buttons are used when operating the CD player, TAPE deck, etc. The function of these buttons are dependent on the function button selected.

¤2ATT (attenuate) button

When the input signal is too high and the voice distorts even by throttling the SR4300 VOLUME control, turn on this function. “ATT” is indicated when this function is activated.

The input level is reduced. Attenuation is invalid for use with the output signal of “REC OUT”.

REMOTE CONTROL RANGE

The distance between the transmitter of the remote control unit and the IR SENSOR of the SR4300 should be less than about 5 meters. If the transmitter is pointed to a direction other than the IR SENSOR or if there is an obstacle between them, remote control may not be possible.

Remote-controllable range

SR4300

60°

Remote control unit (RC4300SR)

LOADING BATTERIES

When you use RC4300SR for the first time, you have to install the batteries. The RC4300SR requires 2 AAA-batteries (2 x 1,5 V) to function.

Note

•Attached batteries are to check basic function of remote control unit.

1.Remove the back cover.

2. Insert the new batteries (AAA type) with correct (+) and (–) polarity.

3. Close until it clicks.

10