Marantz ST7001 manual 7Checking the XM signal strength, and Radio ID, Operation, English

OPERATION

7Checking the XM signal strength

FM/AM TUNER ST7001

	and Radio ID	POWER
1.	Press the POWER ON/STANDBY switch q or ON
	button , to turn on the power.
2.	Watching the display, press the BAND SELECT button
		q
	!0or BAND button c to select the XM mode.

3.Press the DISPLAY button t or . twice. Signal status is displayed.

•The display changes as shown below according to the receiving condition.

Display	Condition
STRONG	Signal strength is good
MARGINAL	Signal strength is marginal	c
WEAK	Signal strength is poor
NO	Loss of the signal

4.Adjust the antenna location until “SIGNAL:STRONG” is displayed.

5.Press the TUNING – button ⁄1to select channel 0 (XM000).

• The Radio ID is displayed.

Radio ID

Note

•If “CHECK ANTENNA” appears in the front panel display, the XM Connect-and-Play antenna may not be connected to the XM terminal on the rear panel of this unit properly.

•You can not select channel “0” if the All channel search mode is not selected.

ti !0

STANDBYON

1 2 3

4 5 6

7	8	9	.
	DIMMER	DISPLAY

10

TUNING

⁄1

	NTE
	E	R
BAND		MENU
A-PRESET		SHIFT
/A-TUNE

CHANNEL/

CONTROL

A/B C/D E/F

G/H I/J T-MODE

SLEEP TIMER MEMO

REMOTE CONTROLLER

RC7001ST

ENGLISH

15