Marantz ST7001 Sleep timer, Last Function Memory, Initialization Of The Microprocessor, English

ENGLISH	OTHER OPERATION
	7 Sleep timer

•The sleep timer function allows the unit to be in standby mode automatically after specific period of time.

1.Press the SLEEP button m on the remote control.

2.Each press of the button will increase the time before shut down in the following sequence.

OFF 10 20 30 60 90 120

3.The sleep timer will be shown for 5 seconds in the display, and it will count down until the time has elapsed. When the programed sleep timer has elapsed, the unit will automatically turn off.

Note that the display will be dimmed when the sleep timer is programed.

4.Press the SLEEP button m. The display shows the remaining time until standby mode begins.

5.To cancel the sleep timer, press the SLEEP button m repeatedly until the display shows "SLEEP OFF".

•When the sleep timer is programed, DIMMER function does not activate.

STANDBYON

1 2 3

4 5 6

7 8 9

DIMMER DISPLAY

10

	TUNING
	NTE
	E	R
BAND		MENU
A-PRESET		SHIFT
/A-TUNE

CHANNEL/

CONTROL

A/B C/D E/F

G/H I/J T-MODE

SLEEP TIMER MEMO

m

REMOTE CONTROLLER

RC7001ST

LAST FUNCTION MEMORY

•This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the power is switched off.

This function eliminates the need to perform complicated resettings when the power is turned on.

•The unit is also equipped with a back-up memory.

This function provides approximately one month of memory storage when the main unit’s power switch is off and with the mains cord disconnected.

INITIALIZATION OF THE

MICROPROCESSOR

•When the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, the initialization of the microprocessor is required by the following procedure.

1.Unplug the mains cord from the power outlet after pressing the POWER ON/STANDBY switch q and setting the standby mode.

2.Holding both the CATEGORY button r and MENU button u, plug the mains cord into the power outlet.

3.Check that the entire display is flashing with an interval of about 1 second, and release your fingers from the 2 buttons and the microprocessor will be initialized.

Note

•If step 3 does not work,start over from step 1.

•If the microprocessor has been initialized all function settings are reset to the default values (the values set upon shipment from the factory).

FM/AM TUNER ST7001

POWER

q r u

22