PART NAMES AND FUNCTIONS
REAR PANEL
ANTENNA | ANALOG OUT | REMOTE | |
| 1 | 2 | CONTROL |
MODEL NO. ST7001 |
| ||
L |
| L | IN |
FM(75Ω) GND AM |
| FLASHER | |
|
|
| IN |
XM |
| R | OUT |
R |
| ||
|
|
| EXTERNAL |
|
|
| INTERNAL |
ENGLISH
AC IN | AC OUTLET |
| SWITCHED |
| 100W MAX |
a b | c d e fg h | i j |
a FM antenna terminal (75 ohms)
Connect an external FM antenna with a coaxial cable, or the supplied FM indoor antenna.
b AM antenna and ground terminals
Connect the supplied AM loop antenna . Use the terminals marked “AM” and “GND”. The supplied AM loop antenna will provide good AM reception in most areas. Position the loop antenna until you hear the best reception.
c XM terminal
See page 14 for connecting information.
h EXTERNAL/INTERNAL switch
Before the unit was shipped from the factory, this switch was set to INTERNAL to enable the remote sensor built into the unit to be used.
Before using the supplied connecting cord to make the connection between the unit and the remote control connectors on a Marantz equipment, set the switch to
EXTERNAL.
Note
•Signals cannot be received from the remote control unit if the switch is kept at EXTERNAL when the unit is to be used on its own.
d ANALOG OUT 1, 2 (analog output) connectors
The audio signals are output from these connectors.
i AC INLET
Plug the supplied mains cord into this AC INLET and then into the power outlet on the wall.
ST7001 can be powered by 120V AC only.
e
The
f FLASHER IN (Flasher input terminal)
This terminal is to control the unit from another zone. Connect the control signal from a Keypad, etc.
g REMOTE CONTROL IN and OUT connectors
Using the supplied remote control connecting cord, these connectors enable this unit to be connected to a Marantz component equipped with remote control connectors. These connections make it possible to control an entire system that centers on the amplifier or other such component.
j AC OUTLET
Connect the AC mains cord of components such as a MD or Tape Deck to this outlet. This SWITCHED outlet provides power only when the ST7001 is turned on.
Caution
•In order to avoid potential
•The capacity of this AC outlet is 100W. Do not connect devices that consume electricity more than the capacity of this AC outlet.
5