2.Press the LEARN (3) button twice. The LED will flash every time you press the button.
3.Press SETUP (9). The LED will extinguish after a few seconds.
Notes:
•Execute a Master Clear before you start learning (see the method above).
•Make sure both remote controls have full batteries before you start learning codes.
•Make sure you do not move the remote controls when pressing the buttons.
•You cannot learn any commands for the following buttons: Learn, Setup, TV, VCR, CBL, DVD, ASAT, DSAT, AUDIO, M1, M2, M3, ShowView/V+ Home Control or directly under the SHIFT button.
•Experiment by learning two or three buttons first (to test compatibility), before you learn all the buttons of your original remote control.
•When the memory is full, one of the Mode LEDs will flash for 3 seconds. You cannot learn any codes when the memory is full. You can, however, erase a mode with codes you stored. You can only erase a full mode.
•By keeping the buttons for the existing remote control pressed for a shorter period, there will be more memory space left for learning codes on the Marmitek remote control. This also diminishes the chance that the remote control learns the wrong codes.
•Experiment with the distance between the remote controls if you have problems learning the codes.
•Some remote controls do not have the infrared LED in the centre. Try experimenting by slightly moving the remote controls (sideways or up/down).
•Tube lighting and bright sunlight can affect the procedure.
•Use the buttons L1, L2, L3 and L4 to learn the codes for which the Marmitek remote control does not have a proper button. If you encounter any problems when learning the codes of buttons, erase the memory and start again.
•You can only learn the codes for one original remote control per mode, e.g. the codes for your DVD remote control under the DVD button. With some combi devices (e.g. a TV with
Learning the commands
1.Point your existing remote control at the Marmitek EasyControl 8 remote control (front to front). Keep a distance of 2,5 cm between the remote controls.
2.Press the SETUP (9) button until one of the Mode LEDs stays lit. Release the SETUP (9) button.
3.Press the Mode button (TV, AUDIO, SAT, etc.) for the device you want to learn. The LED will flash once.
4.Press the LEARN (3) button. The LED will flash once.
5.Press the button on the Marmitek remote control you want to store the new command under. The LED will blink once.
6.Depending on the type of remote control you have, you can use one of two methods:
a.Press the button on the existing remote control you want to learn. Keep this button pressed until the LED on the Marmitek remote control extinguishes. If the LED does not extinguish, but starts flashing, you need to use method B. (If you have just tried method A and want to try method B, first repeat step 5).
b.Press the button on the existing remote control you want to learn. Keep this button pressed as long as you would when using the original remote control.
ENGLISH
EASYCONTROL 8 | 11 |
