Marmitek Easycontrol 8 Home Control Functions, Clearing a macro button, Marmitek X-10 functions

Notes on programming macros

•The first command of a macro always needs to consist of a Mode button (TV, VCR, etc)

•You may have to enter a delay in the macro (e.g. to let your TV warm up). Press PAUSE (23) followed by a numerical key (1-9) to enter a delay of between 1 and 9 seconds. The standard delay between the separate macro commands is half a second.

•The macro buttons can execute both infrared (IR) and radio frequency (RF) commands. This means you can both activate your audio and video equipment and control the lights at the same time (using the Marmitek Home Control TM13). This is ideal for Home Theatre applications. See www.marmitek.com for more information.

Clearing a macro button

1.Press the SETUP (9) button until one of the Mode LEDs stays lit. Release the SETUP button.

2.Press the MACRO (25) button. The LED will flash once.

3.Press the macro button you want to clear (M1, M2 or M3).

4.Press the SETUP (25) button again.

4.8 Home Control Functions

You can control the Marmitek X-10 Modules as follows:

1.Press the Marmitek X-10 button .

2.Use the numerical keys to select the UnitCode of the Module of your choice (1-digit codes do not have to preceded by a ‘0’).

3.Press the button of the function you want to execute (see overview below).

Marmitek X-10 functions:

On: CHANNEL +

Off: CHANNEL -

Brighter: VOLUME +

Dim: VOLUME -

All lights on: Power

All units off: ‘ Mute’

Changing the X-10 HouseCode

The Marmitek EasyControl 8 remote control is set to HouseCode A by default. In most cases you do not need to change this setting, unless another X-10 system in your area causes interference.

1.Press the SETUP button until one of the Mode LEDs stays lit. Release the SETUP button.

2.Press the numerical key(s) for the HouseCode selected (1=A, 2=B, ...... 16=P).

3.Press the -/-- (12) button to confirm the HuisCode. The LED will extinguish.

Note: The HouseCode selected must be the same as the HouseCode used by your Transceiver Module (TM13 or Marmitek Alarm Console).

Home Control and programming macros

If you want to control your lights and appliances you will also need, besides the EasyControl 8, a Marmitek X-10 Home Control Module. This can be plugged into any electrical socket. No hassle with extra cables: extra wiring is not necessary because the

ENGLISH

EASYCONTROL 8 13