INSTALLING YOUR REFRIGERATOR
Select Location
The proper location will ensure peak performance of your appliance. We recommend a location where the unit will be out of direct sunlight and away from heat sources. To ensure your product performs to specifications the recom- mended installation location temperature range is from 55 to 100°F (13 to 38°C).
Outdoor Installation
Only the 3OARM & 6AROM models are suitable for outdoor installations
Building codes may require a ground fault circuit interrupter electrical receptacle to supply electrical power to the refrig- erator for outdoor applications, (see "Electrical Connection" section).
Do not install in a location where the unit will be exposed to direct sun exposure as this may result in unsatisfactory performance.
Cabinet Clearance
Ventilation is required from the bottom front section of the unit. Keep this area open and clear of any obstructions. Adjacent cabinets and counter top can be installed around the unit as long as the front grille and remains unobstruct- ed.
Front Grille
Do not obstruct the front grille. The openings within the front grille allow air to flow through the condenser heat ex- changer. Restrictions to this air flow will result in increased energy usage and loss of cooling capacity. For this reason it is important this area to not be obstructed and the grille openings kept clean. AGA MARVEL does not recommend the use of custom made grilles as air flow may be restricted because of inadequate openings. (See Figure 2).
Leveling Legs
Adjustable legs at the front and rear corners of the unit should be set so the unit is firmly positioned on the floor and level from side to side and front to back. The overall height of your Marvel refrigerator may be adjusted between the minimum (by turning the leveling leg in) and the maxi- mum (by turning the leveling leg out) dimensions as shown in Table A.
To adjust the leveling legs, place the refrigerator on a solid surface and protect the floor beneath the legs to avoid scratching the floor. With the assistance of another person, lean the refrigerator back to access the front leveling legs. Raise or lower the legs to the required dimension by turn- ing the legs. Repeat this process for the rear by tilting the refrigerator forward using caution to prevent the door from opening. On a level surface check the refrigerator for level- ness and adjust accordingly.
The front grille screws may be loosened and the front grille adjusted to the desired height. When adjustment is com- plete tighten the front grille screws. (See Figure 3).
|
| Model | Minimum | Maximum |
|
|
| Height | Height |
|
|
| ||
|
| 30ARM,3OARM, | 33 3⁄4 | 34 3⁄4 |
Front Grille, |
| 61ARM,6ADAM | (85.7cm) | (88.3cm) |
keep this area |
| 6ARM,6ARCM | 33 7⁄8 | 34 7⁄8 |
open. |
| 6AROM | ||
| (86.1cm) | (88.7cm) | ||
|
| MPRO6ARM | ||
|
|
|
| |
|
|
| Table A |
|
|
|
|
|
|
Front | Rear | |
Leveling Legs | ||
Leveling legs | ||
| ||
| Figure 2 |
4
