Master Bilt TAF-27 ERC2, TAF-48 ERC2, TAF-74 ERC2 manual dSPL, 12Hr, Elec, Efan, Cfan, dFin, CoFF

To change the other parameters (Second Level) follow these steps:

Step 1		Press and hold SET and DOWN for 10 seconds. The display
	and	will show dSPL
Step 2		Press SET to change the parameter
Step 3		Press UP or DOWN to change the options, time or temperature
	or	for the current parameter
Step 4		Press SET to accept the new value
Step 5		Press DOWN to go to the next parameter, then go back to Step
		2. After the last parameter is displayed (ALHi), the display will
		go back to the normal operating condition

Note: to scroll down the parameters without changing them, press the DOWN button.

List of Parameters

Here is a list of the parameters that can be changed in the Second Level of programming, as well as their options and ranges.

Note: Master-Bilt’s Set point Temperature (Set) is set at a recommended –10°F at the factory.

Parameter	Displa	Description	Range / Options	Master-
	y			Bilt’s
	Symbo			Factory
	l			Setting
Display Status	dSPL	Information shown	tdAy – time-of-day
		on the display	rSP° – zone temperature	rSP
		during operation	CyCL – cycle between time and
		conditions	zone temperature
			Epr° – evaporator coil temperature
Clock Format	CLHr	Time Format(12 or	12Hr – AM/PM format	12Hr
		24 hours mode)	24Hr – 24 hour format
Temperature	°dSP	Temperature	°F – degrees Fahrenheit	°F
Format		degrees	°C – degrees Celsius
Defrost Type	dFtP	Type of defrost used	ELEC – electric defrost / off cycle	ELEC
		in the application	HgAS – hot gas defrost
Fan Status	EFAN	Enable or not the	no – fan is turned off during defrost	No – for LT
During Defrost		fan during defrost	yES – fan remains on during defrost	yES–for MT
Fan Status	CFAN	Enable or not fan during	on – fan on during normal mode	on
During Normal		normal compressor	CyCP – fan cycles with compressor
Mode		on/off mode
Defrost	dFin	Type of defrost	TdAy – time-of-day setpoint	ddEF–for LT
Interval		interval	CPrn – compressor run time	CPrn–for MT
			tdEF – temperature initiated defrost
			ddEF – demand initiated defrost
Minimum	CoFF	Minimum time that	Range: from 0 to 15 min	2 min.
Compressor		the compressor
Off Time		remain turned off
		10