Lock Upgrade

Function 20

 

 

Level: Master

This function is used to upgrade the memory of your E72. Here are the steps.

1.Obtain the lock serial number.

The serial number is printed on the exterior backplate of the E72.

Or, using the IDT, the serial number appears on the IDT display, as well as, on the header of the audit trail (Func. 15).

2.Obtain upgrade code.

Call SDC at 1-805-494-0622 with your serial number. An SDC customer service representative will take your order and fax back/call back with your upgrade code. Please retain your upgrade code for your records.

OR

Call your local SDC distributor with your serial number. They will obtain your upgrade code and fax back/call back with your upgrade code. Please retain your upgrade code for your records.

3.Install upgrade number into the E72.

Using this function, enter your upgrade code from the back of your upgrade card.

Note: By upgrading the E72’s memory, the lock will reset to the factory defaults. All information currently stored in the memory will be lost. It is recommended before updating your memory, use the IDT to download an audit trail (Func. 15). This will allow you to use the information later to update the E72’s memory. After the upgrade is complete, the E72 is re-initialized and the

ENTRIES

 

VISUAL / AUDIO

1.

 

 

Valid User Code

 

#

2.

2

0 *

Function Number

3.

 

*

Enter Upgrade Number

 

 

Manufacturer Supplied

4.

 

*

Exit

 

See Note

 

 

Note

UPGRADES are PERMANENT even if lock is reset.

LOCK SERIAL NUMBER REQUIRED.

LOCK CANNOT be DOWNGRADED.

ENTER “#” to return to FUNCTION NUMBER (Step 2) and continue programming.

IF ERROR ON ENTRY OR NO ENTRY IN 5 SECONDS, LOCK WILL TIME-OUT. BEGIN AT STEP 1.

Page 28

Function 35

IR Interrupt

 

 

Level: Grand Master

This function PREVENTS IR transmission between the lock and the IDT Upload/Download device for extra security.

To DISABLE the IR Interrupt, enter "0".

To ENABLE the IR Interrupt, enter "1".

ENTRIESVISUAL / AUDIO

1.

 

Valid Code

 

 

 

 

 

 

 

2.

 

 

 

 

 

 

#

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Function Number

3

 

5

 

*

 

3.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Select One:

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

(0) DISABLE

 

 

0

 

*

 

 

 

 

 

 

 

 

 

 

 

 

(1) ENABLE

 

 

1

 

*

 

4.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Exit

 

 

 

*

 

 

 

 

 

 

 

 

 

 

 

 

See Note

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Note

The DEFAULT for this function is “0” DISABLED.

ENTER “#” to return to FUNCTION NUMBER (Step 2) and continue programming.

IF ERROR ON ENTRY OR NO ENTRY IN 5 SECONDS, LOCK WILL TIME-OUT. BEGIN AT STEP 1.

Page 29