Maytag 8101P641-60 Roof-Vented Installation, Prepare The Venting Blower, ports

STEP 3: Prepare The Venting Blower

4.Reassemble the blower wire. See Figure 14.

5.Rotate the unit so that the exhaust ports face the rear of the cabinet. See Figure 16. When you insert blower unit, blower wire must be like figure 15.

6.Place blower unit back into cabinet. Check that the exhaust ports face towards the rear of the cabinet. See Figure 16.

7.Reattach the blower plate to cabinet so the exhaust ports and blower plate opening are aligned. Attach with one blower unit mounting screw and then one blower plate mounting screw. See Figure 17.

	blower
	unit
Figure 14	exhaust	exhaust	Figure 16
	Figure 15 ports	ports
		blower plate
		mounting screw

Roof-Vented Installation:

1.Remove one blower unit mounting screw and one or two blower plate screw(s). Remove the blower plate from cabinet. See Figure 18.

2.Use side cutter or thin snips to cut and remove knockouts "A" from Blower plate. Discard knockouts. Be careful not to distort the plate. See Figure 19.

3.Carefully lift the blower unit out of the microwave oven.

4.Rotate blower unit 90° so the exhaust ports face the upper of the cabinet. See Figure 20.

5.Reassemble the blower wire.

6.Place blower unit back into microwave oven.

7.Reattach blower plate to microwave oven. Attach with the one blower unit mounting screw and then the one or two blower plate mounting screw(s). See Figure 21.

8.Attach the exhaust adapter to the blower plate by sliding it into the Guide. See Figure 22.

		blower plate
blower unit
		back plate
blower unit		blower unit
		mounting screw
exhaust ports
	Figure 17
		blower plate
		mounting screw
blower unit		blower plate
		back plate
		blower unit
	parts “B”	mounting screw
		Figure 18
		Knockouts “A”

blower plate

Figure 19

blower unit

Exhaust

blower plateadaptor mounting screw

Back of oven

blower		blower unit
unit	blower plate
		mounting screw
Figure 20	Figure 21	Figure 22

12