![](/images/new-backgrounds/1271900/27190025x1.webp)
Use where local codes permit connecting
DE
CF
A.
B.
C. Neutral prong
D. Spade termina/s with up turned ends
E. _/4" ( !. 9 cm) UL listed strain relief
£Ring terminals
C. Neutral (white or center wire)
1.I.oosen or remove center
2.Connect neutral wire (white or center wire) of power supply cord to the center,
3.Connect the other wires to outer terminal block screws. Tighten screws.
I I
4.Tighten strain relief screws.
5.Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with
6.You have completed your electrical connection. Now go to "Venting Requirements."
Use where local codes permit connecting
Direct wire cable must have 5 ft (1.52 m) of extra length so dryer can be moved if needed.
Strip 3V2" (8.9 cm) of outer covering from end of cable. Strip insulation back 1" (2.5 cm). If using
A
B | _?,.9era) |
A. External ground conductor screw
B. Neutral ground wire
C. Center
D. Neutral wire (white or center wire)
E. _4" (1.9 cm) UL fisted strain refief
When connecting to the terminal block, place the hooked end of the wire under the screw of the terminal block (hook facing right), squeeze hooked end together and tighten screw, as
shown.
E
1.I.oosen or remove center