Service and Maintenance (cont’d)
Draining
The water heater should be drained if being shut down during freezing temperatures. Also periodic draining and cleaning of sediment from the tank may be necessary.
1.Before beginning turn “OFF” the electric power supply to the water heater.
WARNING
HAZARD OF ELECTRICAL SHOCK! Before removing any access panels or servicing the water heater, make sure the electrical supply to the water heater is turned “OFF”. Failure to do this could result in
DEATH, SERIOUS BODILY INJURY, OR PROPERTY DAMAGE.
2.CLOSE the cold water inlet valve to the water heater.
3.OPEN a nearby hot water faucet and leave open to allow for draining.
4.Connect a hose to the drain valve and terminate to an ade- quate drain or outdoors.
5.OPEN the water heater drain valve to allow for tank draining.
NOTE: If the water heater is going to be shut down and drained for an extended period, the drain valve should be left open with hose connected allowing water to termi- nate to an adequate drain.
6.Close the drain valve.
7.Follow “Filling the Water Heater” instructions in the “Instructions for Installation” section.
Thermostat Removal/Replacement
1.Turn “OFF” the electrical power to the water heater at the junction box.
WARNING
HAZARD OF ELECTRICAL SHOCK! Before removing any access panels or servicing the water heater, make sure the electrical supply to the water heater is turned “OFF”. Failure to do this could result in
DEATH, SERIOUS BODILY INJURY, OR PROPERTY DAMAGE.
2.Remove the access panel and the insulation block and pad.
3.Lift out the tab as shown below to unclip the terminal cover from the thermostat. The terminal cover can now be removed from the thermostat.
Lift out tab to unclip terminal cover from thermostat.
LOWER THERMOSTAT | UPPER OR LOWER |
WITHOUT HIGH LIMIT | THERMOSTAT WITH |
| HIGH LIMIT |
8. Turn “ON” power to the water heater.
CAUTION
Never use this water heater unless it is completely full water. To prevent damage to the tank and heat- ing element, the tank must be filled with water. Water must flow from the hot water faucet before turning “ON” power.
4.Remove the two wires attached to the thermostat.
5.Remove the thermostat from behind the thermostat bracket.
6.Disconnect wires from thermostat and slide out of the bracket.
7.Place the new lower thermostat in the bracket making sure it fits firmly against the tank.
8.Attach the wires to the new thermostat.
NOTE: Some of the terminals may require
17
