Instructions for Installation (cont’d)
Installation Checklist
HOT | COLD | ||
1. Whether or not the element conversion is made, the model |
|
|
|
|
|
| |
rating plate must be marked. Using a hard point ink pen, |
|
| |
check the appropriate block within the model rating plate, |
|
| |
which is located adjacent to the lower access panel. |
|
| |
2. Is the fuse or circuit breaker size correct as shown in the |
|
|
chart in the “Product Specifications” section? | HOT | COLD |
| CONDUIT |
|
3.Are the wires from the circuit breaker or fuse service to the water heater’s junction box on the correct wire size (gauge) as shown in the chart in the “Product Specifications” section?
4.Is the new
5.Is the water heater completely filled with water? See “Filling the Water Heater” instructions in the “Instructions for Installation” section.
6.Will a water leak damage anything? See “Locating the New Water Heater” in the “Instructions for Installation” section.
TEMPERATURE-
PRESSURE
RELIEF VALVE
DISCHARGE PIPE (Do not cap or
plug)
7.Are the cold and hot water lines connected to the water heater correctly? See “Water Piping” instructions in the “Instructions for Installation” section.
8.Is there adequate clearance for maintenance around the water heater?
9.Do you need to call your electric company to check your wiring?
6″ AIR GAP
FLOOR DRAIN
MODEL RATING PLATE
14
