Service and Disassembly Procedures
!WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit and discharge capacitor through a 10,000 ohm resistor before attempting to service, unless test procedures require power to be connected. Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Removal
1.Disconnect power to the machine.
2.Remove Torx™ screw securing Strike to Tub.
5.Check for proper Door Latch adjustment to ensure proper door sealing.
Outer Door
Removal
1.Disconnect power to the machine.
2. Remove the Inner Door Panel. (See paragraph Inner
Door Panel removal).
3. Remove 2 screws securing PC Board Base to Inner 
Door Panel.
4. Lift off Latch Assembly.
5. Lay Outer Door to it's fully open position.
6. Prop door open, by inserting an object into the 1/8" dia. hole in hinge bracket.
DOOR GASKET
The Door Gasket provides a seal between the Door and the Tub.
Removal
1. Open Door.
2. From either corner, pull gasket up and out of tub recess.
Replacement
1. To ease installation, wet gasket with water.
2. Starting in the lower right corner, Gently work gasket into the recess of Tub up the right side.
3.With other end, place gasket flush with the Tub in lower left corner.
4.Gently work gasket in to the recess of the Tub, up the
left side, and across the top.
©2004 Maytag Appliances Company | 16022783 Rev. 0 | 34 |
