Maytag MFI2568AEW manual By Stephen Beck Use at your Own Risk

13.Clean the PCB with the Q-Tips and rubbing alcohol. This removes the residue that came out of the solder when you heated it. Check to be sure that you don’t have any solder blobs bridging the gap between the brown sections of the board. If you do, re-melt the solder and remove the bridge using the de-soldering bulb. You should be able to see a clear green line between the positive and negative sides of each cap you soldered. (Fig 18)

© 2007 Stephen Beck

Check for, and remove solder bridges across

here

Fig. 18

14. The completed board looks like this on top. (Fig 19)

© 2007 Stephen Beck

Fig. 19

15.Well, if all looks the same on the solder side as when you first started, and you haven’t had to reach for the burn cream, give yourself and your helper (if you have one) a pat on the back. You’re well on your way to being able to get the fridge back together and cooling off a refreshment of your choice. ☺

© 2007 by Stephen Beck V1.0 Page 14 of 19 Use at your Own Risk