3.Turn the 1.65 mm Natural gas broil burner orifice hood counterclockwise to remove.
A
To Convert Surface Burners
1.If installed, remove the burner grates.
2.Remove the burner caps.
3.Using a Phillips screwdriver, remove the burner base.
A 
C |
B |
D |
A. 1.65 mm Natural gas broil burner orifice hood
4.Install the Number 57 LP gas broil burner orifice hood, turning it clockwise 4 or 5 turns. Do not overtighten.
57 
A
A. Number 57 LP gas broil burner orifice hood
5.Place the broil burner on the broil burner orifice hood. Insert the broil burner locator pin in the hole in the oven back.
6.Position the broil burner against the roof of the oven cavity and attach with screw.
A B
C
D
A. Broil burner orifice hood
B. Broil burner
C. Broil burner locator pin
D. Broil burner locator hole
A. Burner cap
B. Gas tube opening
C. Burner base screws
D. Burner base
4.Apply masking tape to the end of a ⁹⁄₃₂" (7.0 mm) nut driver to help hold the Natural gas orifice spud in the nut driver while changing it. Press nut driver down onto the Natural gas orifice spud and remove by turning it counterclockwise and lifting out. Set the Natural gas orifice spud aside.
A
A. Natural gas orifice spud
Use the following chart for correct LP gas orifice spud for each burner. Refer to the rating plate on the lower right side of the front frame for proper sizing of LP gas orifice spuds for each burner location.
LP Gas Orifice Spud Chart
Burner Rating | Color | Size | ID Number |
4,000 BTU | Blue | 0.64 mm | 64L |
5,000 BTU | Yellow/white | 0.70 mm | 70L |
7,000 BTU | Yellow/green | 0.84 mm | 84L |
8,000BTU | Yellow/black | 0.85 mm | 85L |
9,100 BTU | Clear | 0.91 mm | 91L |
10,500 BTU | Green | 0.97 mm | 97L |
11,000 BTU | Yellow/brown | 0.99 mm | 99L |
14,000 BTU | Red | 1.14 mm | 114L |
14,200 BTU | Yellow/orange | 1.07 mm | 107L |
|
|
|
|
5.Replace the Natural gas orifice spud with the correct LP gas orifice spud. See the “LP Gas Orifice Spud Chart.”
6.Replace burner base and hand tighten the screws.
15
