Maytag W10258096A Install Anti-Tip Bracket, Make Gas Connection, Typical flexible connection

Install Anti-Tip Bracket

1.Remove the anti-tip bracket that is taped in the storage drawer.

2.Determine which mounting method to use: floor or wall.

If you have a stone or masonry floor you can use the wall mounting method.

3.Determine and mark the edge of the range in the cutout space. The mounting bracket can be installed on either the left side or right side of the cutout. Position mounting bracket in cutout so that right (or left) edge of the bracket is

⁹⁄₁₆" (14.5 mm) from the marked edge of the range, as shown.

A

B

C

A.Anti-tip bracket

B.Mark edge of range.

C.⁹⁄₁₆" (14.5 mm)

4.Drill two ¹⁄₈" (3.0 mm) holes that correspond to the bracket holes of the determined mounting method. See below.

Floor Mounting

A B

A. #12 x 1⁵⁄₈" screws

B. Anti-tip bracket

Wall Mounting

AB

A. #12 x 1⁵⁄₈" screws

B.Anti-tip bracket

5.Using the Phillips screwdriver, mount anti-tip bracket to the wall or floor with the two #12 x 1⁵⁄₈" screws provided.

Make Gas Connection

WARNING

Explosion Hazard

Use a new CSA International approved gas supply line.

Install a shut-off valve.

Securely tighten all gas connections.

If connected to LP, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column.

Examples of a qualified person include:

licensed heating personnel,

authorized gas company personnel, and authorized service personnel.

Failure to do so can result in death, explosion, or fire.

Typical flexible connection

1.Apply pipe-joint compound made for use with LP gas to the smaller thread ends of the flexible connector adapters (see B and G in the following illustration).

2.Attach one adapter to the gas pressure regulator and the other adapter to the gas shutoff valve. Tighten both adapters.

9