7.Replace burner cap.
8.Repeat steps 1 through 7 for the remaining burners.
9.Place Natural gas orifice spuds in plastic parts bag for future use and keep with the package containing literature.
10.Replace burner grates.
11.Reinstall storage drawer. See the “Replace Oven Racks and Storage Drawer” section for instructions.
12.Reinstall oven door. See the “Oven Door” section in the Use and Care Guide.
13.Complete installation. See “Make Gas Connection” and “Electronic Ignition System” sections.
Checking for proper cooktop burner flame is very important. The small inner cone should have a very distinct blue flame ¼" to ½" long. The outer cone is not as distinct as the inner cone. LP gas flames have a slightly yellow tip.
IMPORTANT: You may have to adjust the “LO” setting for each cooktop burner.
Natural Gas Conversion
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect
Reconnect the
Failure to follow these instructions can result in death or serious burns to children and adults.
1.Turn manual shutoff valve to the closed position.
2.Unplug range or disconnect power.
B
A
C
A. To range
B. Shutoff valve (closed position)
C. Gas supply line
To Convert Gas Pressure Regulator
1.Remove oven racks from inside the oven cavity.
2.Remove the storage drawer. See “Replace Oven Racks and Storage Drawer” section.
3.Remove the oven door. See “Oven Door” section in the Use and Care Guide for oven door removal instructions.
4.Using a Phillips screwdriver, remove the 2 oven bake burner cover screws located at the rear of the oven.
A
B
A. Bake burner cover
B. Bake burner cover screws
5.Lift up and remove oven bake burner cover.
6.Remove the 3 bake burner screws and set aside.
7.Swing the bake burner to the side and lift it off the oven orifice and set aside.
A
B
B
A. Oven orifice
B. Bake burner screws
8.Locate gas pressure regulator at the2rear of the range.
IMPORTANT: Do not remove the gas pressure regulator.
9.Unscrew the regulator cap and remove the plastic cover.
A
B
A. Plastic cover
B. Regulator cap
16