| How to Operate the MA6600, con’t | |
How to Operate the MA6600, con’t |
| |
Jumpers | Using Output 2 | |
| The MA6600 has provisions for connecting an external | |
| Power Amplifier (to drive Loudspeakers in another room) | |
| and an external sensor for remote operation of the MA6600 | |
| from that room. With an external Power Amplifier con- | |
| nected (as illustrated on the McIntosh Connection Diagram | |
| separate sheet “Mc1B”), press the Front Panel OUTPUT 2 | |
Figure 40 | ||
button followed by pressing the OUTPUT 2 | ||
Note: The McIntosh Jumpers must be connected, between | ||
switch On or Off the external Power Amplifier. | ||
the above mentioned jacks, when the MA6600 Internal |
| |
Power Amplifier is to be used. | Reset of Microprocessors | |
The second way is to use both a separate power amplifier | In the unlikely event the controls of the MA6600 stop | |
and the MA6600 | ||
functioning, the microprocessors can be reset by perform- | ||
pair of Loudspeakers to the separate power amplifier and | ||
ing the following: | ||
the second pair to the MA6600. Refer to the MA6600 Out- | ||
1. Press the STANDBY/ON | ||
put Connection Diagrams located on the separate folded | ||
ly five seconds. | ||
sheet “Mc1B” and figure 41 below. | ||
2. When the MA6600 cycles On then Off, release the | ||
| STANDBY/ON | |
| 3. When the STANDBY/ON LED is illuminated press the | |
| STANDBY/ON | |
| normal operation. | |
| Note: This can be performed with the MA6600 On or in | |
| the Standby Mode. |
Figure 41
Note: The MA6600 VOLUME Control will affect the sound level of all the Loudspeakers.
Resetting the MA6600 to default settings
If it becomes desirable to reset all the adjustable settings (Setup and Trim Settings) to the factory default values, perform the following:
SOURCE: CD1 15%
Figure 17
20