
Standard 1 |
|
|
Picture Adjust | Menu Position | |
Fine Menu 1 | Language | English |
Fine Menu 2 | Status Info. | Enable |
Input Signal | ||
RGB/HD Adjust | Blanking Memory | Memory 1 |
Display | Blanking Top | 0 |
OSD/Blanking | Blanking Bottom | 0 |
Config. | Blanking Left | 0 |
| Blanking Right | 0 |
Figure 31
Menu Position - There are nine different positions On- Screen to display the menus.
Status Info. - Displays
Enable: Displays the current status for a set amount of time in the upper right- hand corner of the screen.
Disable: The information is not displayed.
requesting confirmation after press- ing either the PROJ OFF
Disable: Switches Off power to the projector without the option provided by the confirmation message.
Enable: The confirmation message will appear after press- ing either
Blanking Memory - There are three memory locations capable of storing how much projected image (top/bottom/sides) will be cut off by black bands (masking) to pre- vent viewing the undesirable parts of the image.
Memory
Off: Switches Off the blank- ing mode Off. No mask- ing occurs.
Config. Settings
The items in the configuration menu determine how the MDLP1 Projector interfaces with other equipment, such as motorized projection screens. There are also settings dealing with the MDLP1 Projection Lamp. Refer to figure 32 and your McIntosh Dealer for additional information and/or assistance.
Standard 1 |
|
|
|
Picture Adjust | Auto Power Off | Enable | |
Fine Menu 1 | Trigger 2 Full | On | |
Fine Menu 2 | Trigger 2 | Normal | On |
Input Signal | Trigger 2 | Zoom | On |
RGB/HD Adjust | Trigger 2 | On | |
Display | Trigger 2 | Through | On |
OSD/Blanking | Remote Control |
| |
Config. | Reset Lamp Life |
| |
| Reset All |
|
Figure 32
Auto Power Off - This feature allows for the MDLP1 to be switched Off automatically 10 minutes after there is a loss of a video signal on the currently selected input, thus con- serving the projectors lamp life. Enable: This setting will activate the
feature. Approximately nine minutes after there is a loss of the video signal, an
appear. If the MDLP1 doesn’t receive a video signal on the currently selected input or a new command is not issued via
the Control Panel or Remote Control, the MDLP1 will switch Off about one minute later. Refer to figure 33.
Disable: The Auto Power Off Feature is switched Off.
Tigger 2 - Is activated by changing the Aspect Ratio (Full, Normal, Zoom,
28