McIntosh MDLP1 owner manual Lamp at this time, a

Figure 35

Reset of Microprocessors

In the unlikely event the controls of the MDLP1 stop func- tioning, the microprocessors can be reset by disconnecting the AC Power Cord from the MDLP1, waiting for 5 min- utes and then reconnecting the AC Power Cord.

Figure 39

How to Operate the MDLP1, con’t

Normal, Zoom, V-stretch and Through) set to ON a 12VDC output will appear at the Trigger 2 Output Jack; when set to OFF, 0V appears at Trigger 2 Output Jack.

Remote Control - Selection includes the two built in sen- sors along with any external sensor(s) connected via the external IR Input Jack or just external sensor(s). Refer to page 5, General Information Note 6. Wireless: Selects external sensor(s) only.

Wired: Selects the two internal sensors and any external sensor(s) connected to the MDLP1.

Note: When making a change to the cur- rent menu setting, the ENTER Push- button on the MDLP1 Control Panel must be used to effect the desired change.

Reset Lamp Life - The projection lamp used in the MDLP1 has a maximun life expectancy of 2,000 hours.

If at any time you would like to know how many hours of use are left for the lamp, press the INFO Push-button on the Remote Control and the On-Screen Display will appear indicating the number of hours remaining. Refer to figure 34. When there is aproximately

Information
Video Input	HDMI 1 - 1080p
Picture Mode	User 1
Gamma	A
Aspect	Normal
Lamp Mode	Economy
Iris	F6.0
Lamp Life	921 Hours
Total Time	3653 Hours

Figure 34

100 hours of lamp life remaining, an On-Screen Warning Message will ap- pear briefly. Refer to figure 35. If you

	have chosen not to replace
Warning	the lamp at this time, a
Lamp Life 100 Hours	second warning message
	will appear with approxi-

		mately 5 hours remaining.
	Warning	Refer to figure 36. Finally,
		the last warning message
Lamp Life 5 Hours		will appear On-Screen,
	Figure 36	the MDLP1 Projector will
		shut Off and the Control
		Panel WARNING/LAMP
	Warning	LED will illuminate red.
		Refer to figure 37.
Lamp Life 0 Hours		After your McIntosh
	Figure 37	Dealer has replaced the
		Projector Lamp, check to
		make sure the Lamp Life
Reset Lamp Life ?		has been reset by pressing
		the INFO Push-button on
Yes	No	the Remote Control. The
Figure 38		On-Screen Display should
		indicate 2,000 hours. If it
		was not reset please do it
	at this time by selecting the Reset Lamp
	Life from the On-Screen Menu and then
	select YES and press the ENTER Push-
	button. Refer to figure 38.
Reset All - If it becomes necessary to reset all the menu
	settings back to factory defaults (except for
		the Lamp Life Setting),
	Reset All ?	select the Reset All from
Yes	No	the On-Screen Menu and
		then select YES and press

the ENTER Push-button. Refer to figure 39.

29