Installation
OUTSIDE VERTICAL INSTALLATIONS:
To accomplish a outside vertical pipe installation, follow steps 1 through 5 in the
“INSIDE VERTICAL INSTALLATIONS - FREESTANDING”
section and then finish it by performing the following (refer to Figure 15).
1.Install a tee with clean out on the outside of the house.
2.Install PL vent upward from the tee. Make sure that you install support brackets to keep the vent straight and secure.
3.Install ceiling thimble and secure the flashing as you go through the roof.
4.Ensure that the rain cap is approximately 24” (600 mm) above the roof.
Rain cap |
|
Flashing |
|
| 24" |
| (61 cm) |
| 3" (7.5 cm) |
4" | Clearance |
| |
(10 cm) | Support |
| |
| bracket |
| Tee with |
| cleanout |
| Type "PL" |
| vent |
Figure 15: Outside Vertical Installation.
HEARTH MOUNT INSTALLATION: |
|
|
|
| ������ ������� | Refer to Figures 16 and 17. | |
| �� �������� ���� | 1. | Install the hearth pad. |
|
|
| |
Flue | ��� ����� ��� ������ | 2. | Lock fireplace damper in the |
������� �� ��� ��� |
| open position. | |
Connector | ���� ��� �� ����� |
| |
|
| 3. | Install a positive flue connector |
|
|
| at the fireplace dampers or |
|
|
| seal the chimney at the top. |
|
| 4. | Connect a tee to the exhaust |
|
|
| pipe. |
|
| 5. | Install flexible stainless steel |
��������� ��� |
|
| liner or listed pellet vent to |
|
| the top of the chimney. | |
| ��� �� |
| |
|
|
| |
| ���� ��� |
|
|
| ����� |
|
|
| ���������� |
|
|
������� ��������� | ����������� ����� |
|
|
Figure 16: Freestanding hearth mount installation.
13
