Installation
DECIDING WHERE TO LOCATE YOUR PELLET APPLIANCE:
1. Check clearances to combustibles.
2. Do not obtain combustion air from an attic, garage or any unventilated space. Combustion air may be obtained from a ventilated crawlspace.
3. Do not install the stove in a bedroom.
4. You can vent the stove through an exterior wall behind the unit or connect it to an existing masonry or metal chimney (must be lined if the chimney is over 6” (15 cm) diameter, or over 28 inches² (180 cm²) cross sectional area). An interior vent can be used with approved pipe passing through the ceiling and roof.
5. Locate the stove in a large and open room that is centrally located in the house. This will optimize heat circulation.
6. The power cord is 8 feet (2.43 m) long and may require a grounded extension cord to reach the nearest electrical outlet.
REMOVING PELLET STOVE FROM PALLET: |
|
1. | Remove the right and left hand cabinet sides by |
| loosening the three (3) |
| of the each panel. |
2. | Remove the screw located on the front of the cabinet |
| side, below the louvers and loosen the screw behind |
| the ash door. |
3. | Using a 5/16” socket of flat head screwdriver, remove |
| the three (3) wood screws that are holding the |
| bottom of the stove to the pallet. There is one (1) |
| screw behind each side panel and one (1) at the back |
| behind the back grill. |
4. | Install the four (4) leveling legs into the nuts in the |
| base. |
5. | Close the side panels. |
Figure 1: Screws to take out to remove stove from |
|
pallet. |
|
5
