Mega Catch Mini technical manual Installing Hopper Lid

Installation

2

1

3

Figure 31: Installing Hopper Lid.

Installing Hopper Lid:

1.Attach the hopper brackets to the back of the unit with a screw in each top holes of the brackets (#1 in Figure 31). Do not tighten these screws until all six (6) screws are in place.

2.Lay the hopper lid in place, slide the bushing into the bracket, and attach the lid to the brackets (#2 in Figure 31). The screw must go through the bushing in the bracket then into the hopper cover.

3.Install the screw in the bottom hole on both brackets (#3 in Figure 31).

4.Let the hopper lid lay flat on the stove top then tighten the four (4) bracket screws.

FAN KIT INSTALLATION:

1.Please check your fan for damage, if it has been damaged, contact your dealer, distributor or courier company to have the fan replaced before starting this installation.

2.Remove both cab panels. Remove the screws above the door on both sides (Figure 28) and ensure the screws behind the ash box, one on each side (Figure 29) and the three (3) on each panels at the back (Figure 30) are loosened. Slide the front of the cab panels out then slide the back of the cab panels out from under the three (3) screws at the back (Figure 30). Note: The slider knob will need to be removed if installed.

3.Slide the fan into place between the bracket (see Figure 32 & 33).

4.Using a flat head screwdriver or a 1⁄4” socket fasten the fan in place with two (2) screws on each side.

5.Plug the white and purple wires into the fan.

6.Close the cab panels by following the instructions in step 2 in reverse.

Figure 32: Behind the right cab panels. Figure 33: Behind the left cab panels.

21