DESCRIPTION OF DISPLAY MARKS
Deflating
Inflating
Measurement error
Measuring
Low battery
PREPARATION BEFORE TAKING A MEASUREMENT
Battery installation:
-Pull off the battery cover in the same direction as the arrows are pointing.
-Install 2 pcs. alkaline AAA bat- teries, noting the proper orien- tation of positive and negative terminals of the batteries in the battery compartment.
-Replace the battery cover.
-If the low battery symbol appears on the display replace both batteries.
-It is recommended that you use Alkaline batteries since they are functioning for a lon- ger period of time.
-Remove the batteries if the unit is not being used for a long peri- od of time.
Applying the waste cuff:
-With your palm side up, center monitor on your wrist and apply the cuff so that the cuff’s edge should be approximately 1 cm from your palm.
-Do not apply wrist unit on top of a shirt sleeve.
-Wrap the cuff snugly around your wrist and attach using the fastener. The top and bottom edges of the cuff should be tighten- ded evenly around your wrist.
-Any gab between the wrist and cuff will affect the result of the measurement.
-The fabric cuff can be folded down for ease of viewing the dis- play.
TAKING A MEASUREMENT
-After the cuff has been properly placed on either the right or left wrist, press the Start/Stop button. All symbols on the display will appear.
-After the display reads "0" the "Fuzzy Logic function will auto- matically inflate to an approximate pressure and will then begin to slowly deflate as it takes the measurement. When the measure- ment is done the heart symbol will be shown on the display and the systolic and diastolic values be shown in the display after 5 sec. will the pulse be shown in the display. Now will the values be
43
