UK
INTRODUCTION
To get the best out of your new espresso maker, please read through these instructions carefully before using it for the first time. We also recommend that you keep the instructions for future reference, so that you can remind yourself of the functions of your espresso maker.
SAFETY MEASURES
Normal use of the espresso maker
•Incorrect use of the espresso maker may cause personal injury and damage to the appliance.
•Use the espresso maker for its intended purpose only. The manufacturer is not responsible for any damage resulting from incorrect use or handling (see also the ‘Guarantee Terms’ section).
•Use only accompanying accessories or those recommended by the manufacturer.
•The espresso maker may only be connected to 230 V, 50 Hz.
•The espresso maker or cord must not be immersed in water or any other liquid.
•Do not touch the espresso maker with wet hands.
•Never leave the espresso maker unattended when in use and keep an eye on children.
•Never put hot or boiling water in the reservoir. Use cold water only. Ensure the appliance is switched off when filling with water.
•The water level in the reservoir must be between the MAX and MIN marks on the water level indicator on the side of the reservoir.
•Never use the brewing function or the frothing function for more than one minute at a time, and do not use them at the same time.
•The metal parts get very hot during use. Touch the plastic parts and handles only.
•The espresso maker should never be switched on unless it contains water or descaler.
•
•This espresso maker is not suitable for commercial or outdoor use.
Where to put the espresso maker
•Always place the espresso maker at a safe distance from heat sources such as ovens, cooking rings or similar.
•Always place the espresso maker at the back of the kitchen counter.
•Do not cover the espresso maker.
•The espresso maker must not be placed anywhere with an ambient temperature around or below freezing point (0° C). If the water in the reservoir freezes it may damage the appliance.
•Do not allow the cord to hang over the edge of a table/ counter, and keep it away from hot objects and naked flames.
Cord, plug and mains socket
•Check regularly that neither the cord nor plug is damaged and do not use the espresso maker if it is, or if it has been dropped or damaged in any other way.
•If the espresso maker, cord or plug is damaged, the appliance must be inspected and, if necessary, repaired by an authorised repair engineer, otherwise there is a risk of electric shock. Never attempt to repair it yourself.
•Remove the plug from the socket before fitting or removing the filter, before cleaning, or when the espresso maker is not to be used for a while.
•Avoid pulling the cord when removing the plug from the socket. Instead, hold the plug.
•The cord must not be twisted or wound around the appliance.
•Keep the cord away from heat sources and the hot parts of the espresso maker.
•Check that it is not possible to pull or trip over the espresso maker cord or any extension cord.
KEY |
|
|
| |
1. | Control panel |
|
|
|
2. | Steam regulator |
|
|
|
3. | Water reservoir |
|
|
|
4. | Steam nozzle |
|
|
|
5. | Drip tray | 6. |
|
|
6. | Filter holder | 7. | 8. | |
7. | Release lever |
|
| |
|
|
| ||
8. | Handle |
|
| 12. |
9. | Filter, 1 cup |
|
| |
|
|
| ||
10. Plastic insert |
|
|
| |
11. Sealing ring | 10. |
| 9. | |
12. Filter, 2 cups |
| |||
13. Tamper | 11. |
|
| |
| 13. |
| ||
14. On/Off knob |
|
| ||
a.Frothing position
b.Off position
c.Heating position
d.Brewing position
15.Brewing head (underneath the upper section of the espresso maker)
14. | a. b. c. d. | 2. | ||
1. |
|
|
| |
|
|
|
| 3. |
15.
4.
5.
PRIOR TO FIRST USE
Each individual espresso maker is checked at the factory, but for safety’s sake, after unpacking the appliance, you should check carefully that it has not been damaged during transport.
Place the espresso maker on a flat, stable surface, such as a kitchen counter.
Flushing through
The espresso maker should be flushed through before it is used for the first time.
•Pour water into the reservoir (3) up to the MAX mark.
oThe reservoir can be filled while it is on the espresso maker, or alternatively it can be taken off and filled directly under
the tap and then put back into place. Remember to put the lid on when the reservoir has been filled. When replacing the reservoir, ensure that the valve in the bottom of the reservoir fits into the connector on the espresso maker itself.
•Check that the steam regulator (2) is completely closed by turning it clockwise, as otherwise water will come out of the steam nozzle (4) when you flush it through.
•Place a container (e.g. a large cup) beneath the brewing head (15), to catch any water dripping down.
•Turn the on/off knob (14) on the control panel (1) to brewing position (d). The red LED over the heating position (c) goes on.
14
