Memorex MPH7895 manual Telephone Operation, If the Handset is on the Base Unit

(Figure 14)

CIDCW function. See

(Figure 13)

7.After two beeps, press 1 for AM, or press 2 for PM. The unit will announce the new day and time followed by a long beep and will prompt "Please enter next command."

8.Press the REMOTE button to exit the remote mode. Otherwise, the remote function will turn off automatically if not in use for 8 seconds.

TONE / PULSE SETTING

Select the appropriate dialing service by moving the T / P (Tone / Pulse) switch on the bottom of the base unit:

•(T) TONE for Tone service, or

•(P) PULSE for Rotary service.

T / P (Figure 12)

SETTING THE HANDSET RINGER

The handset ringer must be set to ring ON mode in order that to ring when receiving an incoming call. See PROGRAMMING MODE section on page 25.

SETTING USER'S AREA CODE AND NEIGHBORING AREA CODE

In order to use callback function, the user's area code and neighboring area code must be programmed. Neighboring area code is optional. See PROGRAMMING MODE section on page 24.

SETTING THE CALLER ID CALL WAITING (CIDCW) FUNCTION

The CIDCW function must be set to ON position in order to use

PROGRAMMING MODE section on page 24.

TELEPHONE OPERATION

TO PLACE A CALL IN TALK MODE

1.Press the TALK button on the handset. The LCD Display will show "TALK" and the symbol will flash while the unit

auto-scans and will light steadily when it finds a clear channel.

2.Listen for a dial tone.

3.Dial the telephone number. The phone numbers appear on the LCD Display as you enter the number.

4.When finished with your call, press the TALK button or place the handset on the base unit.

TO PLACE A CALL IN STANDBY MODE (PREDIAL MODE)

1.Ensure that the unit is in standby mode.

2.Dial the telephone number or press RE/PA button. If you

make a mistake, press VOL / button to delete the character on the left of the cursor.

3.Press C. BACK button.

4.When finished with your call, press the TALK button or place the handset on the base unit.

TO RECEIVE A CALL

NOTE: If you are expecting incoming calls, the handset must be programmed to RING ON mode. See PROGRAMMING MODE section on 25.

A. IF THE HANDSET IS ON THE BASE UNIT

1.Since the unit features "Auto-Answer", simply pick up the handset from the base cradle

when the phone rings. The LCD Display will show "TALK" and the symbol will light steadily.

2.Start your conversation.

3.When finished with your call, either press the TALK button or place the handset on the base unit.

13

	Page 14	7/5/01, 4:07 PM
MPH7895/04281A(English).put			Adobe PageMaker 6.5C/PPC