Memorex MT2025D manual Wall or Ceiling Mounting

IMPORTANT SAFETY INSTRUCTIONS (CONTINUED)

15.	OVERLOADING
16.	Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock.
	OBJECT AND LIQUID ENTRY
	Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short out parts that could
	result in fire or electric shock. Never spill or spray
	any type of liquid on the product.
17.	OUTDOOR ANTENNA GROUNDING
	If an outside antenna is connected to the
	product, be sure the antenna system is
	grounded so as to provide some protection
	against voltage surges and built-up static
	charges. Section 810 of the National Electric
	Code, ANSI/NFPA 70, provides information with
	respect to proper grounding of the mast and
	supporting structure, grounding of the lead-in
	wire to an antenna discharge product, size of
	grounding conductors, location of antenna
	discharge product, connection to grounding
	electrodes and requirements for grounding
18.	electrodes.
	SERVICING	EXAMPLE OF ANTENNA GROUNDING AS PER
	Do not attempt to service this product yourself as
	opening or removing covers may expose you to	NATIONAL ELECTRICAL CODE
19.	dangerous voltage or other hazards. Refer all servicing to qualified service personnel.
	REPLACEMENT PARTS
	When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer or those that
20.	have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards.
	SAFETY CHECK
	Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the
21.	product is in proper operating condition.
	WALL OR CEILING MOUNTING
22.	The product should be mounted to a wall or ceiling only as recommended by the manufacturer.
	DAMAGE REQUIRING SERVICE
	Unplug the product from the wall outlet and refer servicing to qualified service personnel under the following conditions:
	a. When the power-supply cord or plug is damaged.
	b. If liquid has been spilled or objects have fallen into the product.
	c. If the product has been exposed to rain or water.
	d. If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered
	by the operating instructions, as an adjustment of other controls may result in damage and will often require extensive work by a qualified
	technician to restore the product to its normal operation.
	e. If the product has been dropped or the cabinet has been damaged.
23.	f. When the product exhibits a distinct change in performance–this indicates a need for service.
	HEAT
	The product should be situated away from heat sources such as radiators, heat registers, stoves or other products (including
24.	amplifiers) that produce heat.
	NOTE TO CATV SYSTEM INSTALLER
	This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper

grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

4