Memorex MVD4540B Basic connections, Combination VHF/UHF Antenna with 75 ohm Coaxial Cable

Basic connections

If you are using an antenna system, follow these instructions. If you are a cable (CATV) subscriber, skip ahead to page 14 for the proper connections.

ANTENNA TO DVD/VCR CONNECTION

The DVD/VCR must be connected “between” the antenna and the TV. First, disconnect the antenna from the TV and connect it to the DVD/VCR. Then connect the DVD/VCR to the TV. Below are 3 common methods of connecting an antenna system to a DVD/VCR. Find the type of antenna system you are using and follow the connection diagram.

1

Combination VHF/UHF Antenna with 75 ohm Coaxial Cable

DVD/VCR

IN

(ANT)

75 ohm Coaxial Cable

OUT (TV)

2

Combination VHF/UHF Antenna with 300 ohm Twin Lead (Flat) Wire

DVD/VCR

3

Matching Transformer
300 ohm Input	IN
75 ohm output	(ANT)
(not supplied)	OUT
	(TV)
300 ohm Twin Lead (Flat) Wire

Separate VHF and UHF Antennas			DVD/VCR
		Combiner
		75/300 ohm Inputs
	UHF	75 ohm output
VHF		(not supplied)
			IN
	300 ohm Twin Lead (Flat) Wire
			(ANT)
			OUT
			(TV)
	75 ohm Coaxial Cable

NOTE: If both VHF and UHF antennas have 300 ohm twin lead (flat) wires, use a combiner having two 300 ohm inputs and one 75 ohm output.

NOTES: • A clear picture will not be obtained by the DVD/VCR unless the antenna signal is good. Connect the antenna to the DVD/VCR properly.

•For better quality recording, an indoor antenna or a telescopic antenna is not recommended. The use of an outdoor type antenna is required.

•If you are not sure about the connection, please refer to qualified service personnel.

12

2C51001AE (12-15) 12 18/11/03, 2:38 PM