Memorex MVDP1077 manual Connecting the Unit to a Home Theater System Coaxial Jack

CONNECTION (CONTINUED)

CONNECTING THE UNIT TO A HOME THEATER SYSTEM (COAXIAL JACK)

From S-VIDEO From COAXIAL OUT Jack

OUT Jack

Place the subwoofer, front, rear and center speakers in locations as shown/described here. After correctly positioning the speakers, perform the Tone Test on the AV Amplifier and adjust the Volume control(s) until the desired sound is achieved. For best results, sit in the viewing position and have someone adjust the volumes for you; this will enable you to set the optimal levels.

NOTE: The rear speakers can also be located on the side wall facing the viewing position and each other. Make sure the viewing position is located between the two speakers in this case. Experiment to find optimal position.

1.Front Left Speaker

2.Television

3.Center Speaker–can be located on top or below the Television.

4.Sub-woofer–can be located anywhere in the room.

5.Front Right Speaker

6.Viewing/Listening Position–The best listening position is obtained by positioning the chair, sofa, etc. in the middle of all the speakers.

7.Rear Left Speaker

8.Rear Right Speaker

9.AV Amplifier w/Dolby Digital Decoder

NOTES FOR CONNECTING TO A HOME THEATER SYSTEM:

• Set the TV’s TV/VIDEO button or switch to the VIDEO setting.

• When connecting the unit, refer to the owner’s manuals for the TV and the audio system, as well as this manual.

• When connecting, make sure the power is off and all units are unplugged before making any connections.

• Connect the unit to your TV directly. If you connect the unit through a VCR, the playback picture will be distorted because DVD video discs are copy protected.

• Set the Audio Out on the Audio Setup menu to SPDIF/PCM, see page 20.

• If your TV does not have S-Video input, use the included A/V cable and connect the Video OUT (yellow color end of the cable) to your TV's Video IN jack.

14