Memorex MVDP1077 manual Power Sources Battery Pack INSERTION/REMOVAL, Charging the Battery Pack

POWER SOURCES (CONTINUED)

BATTERY PACK INSERTION/REMOVAL
Follow the diagram below to insert or remove the Battery Pack.
1	2

TO REMOVE: Press down the Battery	TO INSERT: Align the tabs from the Battery
Release button on the rear of the Battery	Pack into the holes on the middle of the main
Pack, then slide the Battery Pack out towards	unit. Then, slide the Battery Pack into the
the rear of the unit.	main unit until it clicks into place.

CHARGING THE BATTERY PACK

The Low Battery indicator will blink at the top left-hand corner of the screen when the Battery Pack is low and needs recharging. With the Battery Pack attached to the unit, insert the small end of the AC adapter into the DC IN jack on the side of the unit. Insert the other end (with the 2 blades) into a conveniently-located AC outlet having 120V AC, 60Hz. The CHARGE indicator on the Battery Pack will blink red as the Battery Pack is charging and light solid red when charging has completed. Remove both the DC plug and the AC-IN plug to disconnect the AC adapter when charging has finished.

NOTES:

• Fully charge the Battery Pack for 12 hours before using it for the first time. After the initial charge, it should take approximately four hours to charge.

• A fully-charged Battery Pack can operate for about 2 and a half hours.

8