
Selecting a station
During normal use the FM tuner should be left in the standby state. This uses a negligible amount of electricity, but ensures that the components of the FM tuner operate at maximum efficiency from the moment you start listening to a station.
If you are not going to use the FM tuner for a period of several days you should switch the unit completely off, at the back panel, and disconnect it from the AC power supply.
To switch on from standby
●Press [ (Previous) or ] (Next).
●Switch on any other equipment connected to the FM tuner which is not part of the Meridian 500 Series.
●Keeping either key held down will step through the preset stations in turn.
Note that before using the FM tuner for the first time you may need to set the preset frequencies for your area; see To programme a preset, page 13.
To switch to standby
●Press Off.
.
The display will show:
If you have other Meridian 500 Series equipment connected to the FM tuner, these units will also switch to standby.
To select a preset station
●Press [ (Previous) or ] (Next) until the display shows the station you want to listen to, or type the number of the preset (remote only).
Using the FM
For example, for Radio 3
the display will show:
Radio 3
tuner
9