Using the Remote control | 8 |
|
|
Starting off with 562
Checking
Before turning on the power, check once again that you have made all the connections correctly and that you have not disturbed any existing con- nections in the process.
Switching on
The power switch is located directly next to the power inlet on the right- rear of 562.
1.Turn on the power switch at the rear of the unit. A small point on the display should now be illuminated.
.
If there are no lights
Check the integrity of your power connections, including any fuses in your supply. If the standby point is still not illuminated and the rest of your system is functioning, contact your dealer for help.
Standby
The entire
1.This standby state ensures that the components operate at maximum efficiency from the moment you start listening. It is perfectly safe and consumes a negligible amount of power. However, when you are not going to use your system for an extended period of time, e.g. when you are going on holiday, we would advise you to disconnect it from the AC power supply.
Basic operation of 562
Note 562 can be used with or without Meridian digital loudspeakers like D600, DSP5000 or D6000. When it used alone as the main system control unit it is normally the ‘System Controller’ and operates exactly as described below. Systems including digital ’speakers always designate the speakers as System Controller and there are some functional differences. The section ‘Using digital speakers with 562' on page28, describes how the operation differs from the following description.
Selecting a source
1.press Source until the input you require is indicated
2.release Source
Selecting a source will bring 562 out of standby.
Putting the 562 in standby
1.press Off, the coloured key on the 562 or
press Standby on the Remote Control
Coming out of standby
To start up the 562 from standby
562 User Guide