ThisUsersection contains informationGuideabout the operating features of the Radiance 10/100Mbps Access Optical Network Unit.
LED Indicators
The Radiance Access Optical Network Unit provides several LEDs on the front panel for the visible verification of unit status and proper functionality. These LEDs can help with troubleshooting and overall network diagnosis and manage- ment. There are separate Activity, Link and Disable indicators for each port. Two additional LEDs, labeled 100 and FD, indicate the speed and duplex mode for the copper port. There is also a Loopback indicator for the fiber port.
The following table describes the function of each LED when lit.
LED | LED |
|
|
Label | Name | Status | Indication |
|
|
|
|
PWR | Power | Steady | Unit is powered ON. |
|
|
|
|
MAN | Managed | Steady | Unit is receiving management packets.* |
|
|
|
|
FD | Full Duplex | Steady | TX port is operating at full duplex. When not lit, |
|
|
| TX port is operating at half duplex. |
|
|
|
|
100 | 100Mbps | Steady | TX port is running at 100Mbps. When not lit, TX |
|
|
| port is running at 10Mbps. |
|
|
|
|
ACT | Activity | Blinking | Port is receiving data. |
|
|
|
|
LK | Link | Steady | Port has a valid link. |
|
|
|
|
DIS | Disable | Steady | Port has been disabled by software. |
|
|
|
|
LBK | Loopback | Steady | FX port is in loopback mode. |
|
|
|
|
*NOTE: A management card must be installed in the chassis at the central office to enable remote management.
Factory Settings
The Access ONU provides several configuration options to meet your network- ing needs. The unit’s default settings are listed below.
Default Hardware Switch Settings
| Parallel (UP) | |
The following switches can be overridden through software commands. | ||
Duplex | Full Duplex (ON) | |
Enabled (ON) | ||
Speed | 100Mbps (ON) | |
|
|
|
Radiance 10/100Mbps Access Optical Network Unit | 13 |
