MGE UPS Systems 2200, 3000 XL 6.2 Glossary, UPS, UPS, load, - Page, Outlets, Bargraph, Equipment, equipment, Fader mode, UPS Driver, Backup time, Booster mode, De-energised, Solution-Pac

	6. Appendices
6.2 Glossary
Backup time	Time that the connected equipment can operate on battery power if AC-input power fails.
Bargraph	Device on the front panel indicating the percent remaining backup time or the percent
	load.
Battery module (additional)	Additional battery modules connected in parallel to increase the UPS backup time.
Booster mode	Automatic UPS operating mode whereby the input-power voltage is increased if it drops
	below a value set in the personalisation parameters, thus avoiding a battery discharge.
De-energised	The UPS must be physically disconnected from the AC-input power.
Equipment	Devices and systems connected to the UPS output.
Fader mode	Automatic UPS operating mode whereby the input-power voltage is decreased if it rises
	above a value set in the personalisation parameters, thus avoiding a battery discharge.
Input circuit breaker	Circuit breaker protecting the upstream distribution system against UPS faults.
Outlets	Pulsar Evolution has a group of four non-programmable outlets.
Output circuit breaker	Circuit breaker protecting the UPS against high overloads or faults on the connected
	equipment.
Personalisation	The parameters for a number of UPS functions may be modified using the UPS Driver
	software to adapt UPS operation to user needs.
RS232 communications port	For UPS connection to a computer via the serial port.
Programmable outlets	Pulsar Evolution has two groups of two programmable outlets. They may be used for
	sequential start-up of protected equipment, shedding of non-priority loads during
	operation on battery power or management of operating priorities to provide the most
	critical devices with more backup time before battery power runs out. These outlets may
	be programmed using the Solution-Pac software on the CD-ROM supplied with the
	UPS.
Solution-Pac	MGE UPS SYSTEMS safety, set-up and supervision software suite on the CD-ROM
	supplied with the UPS.
UPS	Uninterruptible Power Supply.
UPS Driver	Communications software on the CD-ROM supplied with the UPS. It may be used to
	personalise the default settings.
USB communications port	For UPS connection to a computer via the USB port.
	34007115EN/AA - Page 27