Installation and User Manual
Installation and Operation
2.0Scope
This section describes installation requirements, system dimensions, cable connections, and
WARNING: | HIGH VOLTAGE, ONLY QUALIFIED ELECTRICIANS SHOULD INSTALL OR |
| PERFORM MAINTENANCE. |
|
|
2.1Installation Notes
◗The
◗After installation is complete, verify the output voltage is within its rated specifications.
◗Provide overcurrent protection per article NFPA 70 latest revision article
◗Optional output cables must be specified in lengths of 10 feet, cables may have receptacles on the termi- nating end.
◗For installation of conduit, reference NEC Article 348 and 350 and any applicable local electrical codes. Refer to the following installation diagrams for electrical hookup.
2.2MGE UPS Systems Power-Sure™ 700
An efficient installation depends on careful planning and site preparation. Installation of the equipment must be handled by skilled technicians and electricians familiar with the special requirements of
We strongly recommend contacting MGE for system
A good way to insure that the
◗List each piece of equipment, include Model, Voltage, Current and kVA.
◗Calculate kVA of load plus a safety margin.
◗When this is not possible, gather the data by reading the specification plate of the equipment you plan on backing up.
◗One method is to ask the vendor of the computer equipment to supply you with the information you need.
◗Be sure to verify the input supply voltage and the output requirements of the
Installation and Operation | 2 — 1 |