If iGuard is connected to a Router or IP Share then

Appendix D: Glossary

(b)From your PC log-on to your iGuard as Administrator. Enter your username and password for your iGuard.com account. Make sure the "Use Public IP to Register" is set to "Yes" Then Click "Apply" located at the bottom of screen.

Note: Please allow 5 minutes for the DDNS server to be updated with your Current

WAN IP.

If iGuard is connected to a Router or IP Share then;

(d) Go to your Address Translation / NAT / Firewall section of your

ROUTER. Open up TCP port 80 and UDP port 9001, make sure that the TCP port is not currently used by your router, otherwise choose a different port.

Note: Here you are using iGuard to check your current WAN IP and update the DDNS server. Alternatively, if your ROUTER supports DDNS, you can input the above details (b) in your ROUTER. In which case, your ROUTER will update the DDNS server with your current WAN IP.

Micon IP-220E manual If iGuard is connected to a Router or IP Share then

Models: IP-220E

If iGuard is connected to a Router or IP Share then;

If iGuardView is connected to your xDSL line or HUB, then;