Chapter 4: iGuardware
4.Enter the necessary camera configurations. Choose the appropriate frequency (Indoor 60 Hz, Indoor 50 Hz or Outdoor) to prevent flickering on the video feed. Enter a name for the camera in the “Location” box to easily identify it.
5.Click “Next >” to configure the Network Connection.
Fig.6 iGuard Network Setup
“Obtain an IP address by DHCP”
Choose this if you are installing the iGuard on a network with a DHCP server
“Use the following IP Address”
Enter an appropriate IP Address, Subnet Mask and Gateway for iGuard if have a static IP to assign to the iGuard
“Obtain an IP address by Bootp”
Allow iGuard to obtain an IP address using Bootp protocol.
6.Click “Next >” to proceed to xDSL/Cable modem setup.
This section has to be configured to allow iGuard to access the Internet through an xDSL service provider.
11
