Chapter 5: iGuard Web Manager
Fig.38 iGuard Event : Camera A or B Motion Detected
5.2.4.2 Motion Detection
This page allows the administrator to set motion detection functions for the cameras.
i.Camera A (or Camera B) “Enable”
To activate motion detect, the administrator has two options;
a.“Always On” or
b.“On Schedule”, the administrator can set up to 4 different time slots for motion detection.
“Detection Sensitivity”
This will determines level of change before motion capture is triggered.
“Send image every”
Select a value between 1 to 5 seconds.
“Stop sending emails after ## email(s) or image idle for ## second(s)”
iGuard will stop sending on the lower of the two conditions. You can set between 1, 3, 5, 7 and 10 seconds. Emails can be set from 1 to 99999 pieces, or 0 for stop sending email only when image idle occurred.
“Schedule”
If set to “On Schedule” in the above section, the administrator can then input the four preferred schedule time slots for motion detection. Time must be entered in 24hr format.
50
