MicroNet Technology SP616DB, SP624DB user manual Connecting to Power, Connecting to Network

Step 2: Remove the module from the static-free container.

Step 3: Unscrew the cover plate of the expansion slot.

(The slot for single-port module is located at the right side of the switch.) Step 4: Remove the plate.

(Keep it for future use in case you decide to remove this module later.)

Step 5: Carefully slide the module into the slot, along the internal plastic guide rails.

Step 6: Once it is fully slid in, snap in the module to make a proper connection.

Step 7: Fasten the module screws then.

Step 8: Finally, turn on the power.

Connecting to Power

Locate the provided AC power cord.

Step 1: Connect the AC power cord to the receptacle at the back of the switch.

Step 2: Attach the plug into a standard AC outlet with a voltage ranging from 100 to 240 VAC.

Step 3: The power LED on the front panel will come on then.

Connecting to Network

Step 1: First, ensure the power of the switch (and end devices) is turned off.

It may cause electric shock or any possible harm to you if the power is not switched off. Step 2: Prepare cable with corresponding connectors for each type of port in use.

Step 3: Connect one end of the cable to the switch and the other end to a desired device.

Step 4: Once the connections between two end-devices are made successfully, turn on the power.

Now the switch is operational.

5