Microtek Artix Scan1100 manual Installing the software, Connecting the scanner, English

3. Installing the software

Install all the software in your Artix CD-ROM, which includes Microtek ScanWizard Pro and the Microtek Scanner ICC Profiler programs.

To do this: Insert the Artix CD-ROM into your CD- ROM drive; the Scanner Software installer should come up automatically.

Note: If the Scanner Software is not automatically displayed, click Start, select Run and type d:\cdsetup (where d: is your CD-ROM drive).

Click on the “Install” option on each software program in the order that it appears on your screen to install the software.

During installation of ScanWizard Pro, make sure you choose Adaptec SCSI Interface Card as your interface type.

After all the software has been installed, shut down your computer.

4. Connecting the scanner

1.Turn off your PC.

2.Plug the 25-pin end of the SCSI cable into the Adaptec card at the back of the computer. Then plug the 50-pin end of the SCSI cable into the back of the scanner.

Note: See the next section for details on termination.

3.Plug the power cord into the back of the scanner and plug the other end of the power cord into a power source or wall outlet.

4.Press the scanner’s power button on the front panel to turn the power on, then wait for the Ready indicator lights also on the front panel of the scanner to stop blinking and to stay on solid.

5.Turn your PC back on. When Windows starts up, it will automatically detect the scanner.

English

ArtixScan 1100 Hardware User’s Guide 11