English
5. Termination
A terminator is included in your scanner package and should be installed on your scanner in the following situations:
•If the scanner is the only SCSI device in your SCSI chain; or
•If you are daisy chaining the scanner with other SCSI devices AND the scanner is the last device in your SCSI chain.
Normally, a terminator is not required is when the scanner is part of a daisy chain and is NOT the last device in the SCSI chain.
To install the terminator, plug it into the SCSI port at the back of the scanner (beside the cable connecting the scanner to the computer).
6. Troubleshooting
After installing the interface card in your computer and connecting the scanner, you may find yourself unable to use the scanner. This is usually due to any of the situations described below:
Situation A Your interface card is not properly seated in the PCI card slot on your computer.
Situation B Your interface card conflicts with another device.
Situation C Windows 98 / 95 cannot recognize your interface card.
Resolving situation A
Power off your computer, then remove the interface card from your computer.
Resolving situation B
1.Click Start, Settings, and select Control Panel.
2.
3.
A yellow exclamation mark appears next to the message “Adaptec AIC- 7850 PCI SCSI Controller”.
4.Click on the Adaptec
5.Select Resources from the top. The dialog box gives you information about the 3 resources: Interrupt Request (IRQ), Memory Range, and Input/Output range. Any conflict in the 3 resources is detected and displayed in the “Conflicting device list”.
12 ArtixScan 1100 Hardware User’s Guide
