Installation
Fitting the joystick
1.Screw the spring into the holder and tighten by hand. Whilst doing so counterhold the joystick with an SW 9 spanner. Do not turn the spanner!
2.Then fit the middle section onto the spring and tighten by hand whilst continuing to counterhold the joystick. Do not turn the spanner.
3.Then fit the lower section of the joystick and lightly secure in position with the screw supplied and a spring washer. Do not tighten the screw yet.
Turn the lower section around, until the symbol is facing the front.
4.Then tighten the screw with a 3 mm allen key. Continue to counterhold the joystick with an SW 9 spanner. Do not turn the spanner.
Joystick extension
The joystick can be extended if required (special accessory - Miele DBV 100).
Assemble the spring and top section as described above.
Whilst counterholding the joystick with an SW 9 spanner (do not turn), secure the joystick extension to the top section.
Then attach the lower section of the joystick to the extension piece as previously described, turn the symbol to the front and then tighten the screw.
31