Miele DA 2250, DA 2270 EXT Run-onoption, Automatic switch-offof the Intensive setting, Operation

Models: DA 2250 DA 2250 EXT DA 2210 DA 2270 DA 2270 EXT

1 40
Download 40 pages 6.7 Kb
Page 14
Image 14
Automatic switch-off of the Intensive setting

Operation

Automatic switch-off of the Intensive setting

You can set the Intensive setting so that it only runs for 10 minutes before reverting automatically to level III.

￿To set this option, both the fan and the hob lighting must be switched off.

￿Press the run-on option control for approximately 10 seconds. The first power level indicator lamp will light up.

￿Press the joystick

once to the rear or to the front. The second indicator lamp will light up,

then press the joystick once to left. The third indicator lamp will light up,

then press the joystick once to the left or to the front.

The indicator lamps for fan power levels I and IV will flash if the automatic switch-off for the Intensive setting is not activated.

￿To activate automatic switch-off, press the joystick once to the right. The indicator lamps for power levels "I" and "IV" will light up constantly.

￿To deactivate automatic switch-off, press the joystick once to the left.

￿Press the control for the run-on option to confirm the selection and to come out of programming mode.

Run-on option

It is advisable to run the fan for a few minutes after cooking has finished to neutralise any lingering odours in the air, whether you are using air extraction or recirculation mode.

The fan can be set to switch off automatically after either 5 or 15 minutes.

￿After cooking has finished, press the run-on option control whilst the fan is still running.

Press once = The fan will switch off after 5 minutes (left-hand indicator lamp).

Press twice = The fan will switch off after 15 minutes (right-hand indicator lamp).

￿To switch off the run-on option, press the run-on option control again. The appliance will then not switch off automatically.

14

Page 14
Image 14
Miele DA 2270 EXT, DA 2210, DA 2250 EXT Run-onoption, Automatic switch-offof the Intensive setting, Operation