Miele DA 3160 EXT, DA 3190 EXT Installation, T= Depth of carcase K minus depth of appliance G

Installation

Positioning the appliance in the wall housing unit

To position the appliance correctly, cut the spacer strip to required depth T, and then attach it to the back of the appliance.

T= Depth of carcase K minus depth of appliance G

^The depth of appliance G depends on the lightshield being used:

–a Lightshield to match existing kitchen furniture

–b DFB lightshield (optional accesssory)

–c No lightshield.

This is based on a lightshield which aligns with the front edge of the carcase.

If the lightshield is further forward or back, measurement T will need to be adjusted accordingly.

When installing a shelf or partition wall, the building-in space at the back must not be less than 180 mm.

If it is less than 180 mm, position the appliance further back, and reduce measurement T accordingly. The building-in position can be rectified later by adjusting the depth.

^Cut the spacer strip supplied to measurement T .

Score along the groove for the smaller measurement as shown, and remove the surplus.

^Screw the spacer strip to the bottom of the sides of the housing, flush with the rear wall.

^Draw a vertical line up both inside walls of the housing from the front of the spacer strip.

25