Electrical connection
Grounding connection
^The ground lead must be connected to the screw connection point (marked with the ground symbol 8) at the back of the machine.
The machine must only be operated with the voltage, frequency and fusing shown on the data plate located on the rear of the machine, and on the plinth (behind the service panel).
The conversion diagram and the wiring diagram is secured to the inner side of the service panel.
Removing the service panel
Disconnect the machine from the main electrical supply.
^Remove the fixing screws, a, from the service panel.
^Hold the service panel at both sides and pull upwards.
^Unscrew the facing, b. Remove the plastic protective cap.
^See the supplied installation diagram.
Re-assembling the service panel
^Refit the plastic protective cap, facing and service panel in the reverse order to which they were removed.
47
