Changing the door hinging
The appliance is supplied
You will need the following tools:
–A Torx→ 15 and a Torx→ 25 screwdriver,
–a
–a spanner (supplied).
Two people are needed for changing the door hinging.
Removing the door handle
^Pull door handle a towards you. Side section b slides back.
^Pull side section b firmly back out of the guides on the mounting plate.
^Undo the 4 screws (Torx→ 15) in the mounting plate, and remove the handle.
^Remove the cover caps from the opposite side, and fit them into the empty holes.
The hinge parts (hinge plate and hinge pin) must be screwed sufficiently tightly as otherwise the appliance door could fall off. Danger of injury. Also the door may not close fully, which would prevent the appliance from cooling down properly. Take care to secure the hinge plate and pin tightly. Check all screws and tighten them if necessary.
Changing over the door
Caution. The door is not secure as soon as the hinge pin is removed.
^With the help of another person, tip the appliance back slightly.
^Unscrew retaining screw c on bottom right hinge plate d.
38
