Changing the door hinging
^Take the door and guide the upper door bearing bush onto upper hinge pin k.
^Pivot the door and place hinge pin e into hinge plate d. Important. Turn the hinge pin if necessary, so that the tab is pointing to the inside of the door and the notch to the outside. The hinge pin will then click into place.
^With the help of another person, carefully tip the appliance back and tighten retaining screw c. Tighten it using a suitable spanner.
^Align the door with the appliance housing again if necessary using the long slots in the lower hinge plate. Then tighten the screws.
^Replace spacer pin p underneath the
Refitting the handle
Please make sure you follow the instructions below carefully when you refit the handle. The door seal will be damaged if the handle is fitted incorrectly.
^Loosely attach the handle to the opposite side of the door with the two front screws b.
Mounting plate c must be positioned on the side of the door so that when the door is closed it is flush with the side of the appliance.
If this is not the case,
^tighten both grub screws a with a suitable allen key until mounting plate c lines up correctly.
^Then tighten all 4 screws b.
^Slide the side section of handle d into the guides on the mounting plate until it clicks into place.
41
