Changing the door hinging
^Pull out spacer pin p from beneath the
^Open the door.
^Holding the door at the bottom and on the handle side, carefully lift it upwards and off.
This will release hinge pin e with washer o from hinge plate d. If it does not release:
^Press hinge pin e with washer o out of the hinge plate from below.
^Undo screws f and take hinge plate d off.
^Undo the screw of hinge part g on hinge plate d slightly. Fit it into the hole opposite in hinge plate d and tighten up the screw.
^Remove plug h and place it in the opposite hole in the hinge plate.
^Remove cover i.
^Unscrew and remove screw j and refit it into the outer hole of the opposite side.
^Turn cover i through 180°, and fit it into the holes on the other side.
^Screw hinge plate d into position on the opposite side using the two outer long slots only. Do not use the middle hole because you will not be able to align the door later on.
39
