Miele PT 7136 PLUS instruction

Installation of exhaust venting

Determining the position of the exhaust connection

The exhaust connection can be left at the rear of the dryer (factory standard) or moved to the left or right side of the dryer.

Changing the position of the exhaust connection

Remove the cap by turning it counterclockwise.

Press the supplied cover firmly into the rear opening.

Install the exhaust duct as follows.

46

Image 46

Miele PT 7136 PLUS Determining the position of the exhaust connection, Changing the position of the exhaust connection

Contents

Operating and Installation manual Vented Dryer PT 7136 Plus Contents Contents Important Safety Instructions Important Safety Instructions Save These Instructions Guide to the dryer Control panel Jog shuttle Display functionMain menu Program selection possibility Menu Program selection SettingsBasic menu of a drying program Language Before using for the first timeWelcome screen Set the time of day Fabric care labels UseDrying tips Sort the laundry Load the laundry Insert coins if operated by coin mechanism Select Low temp. and/or TimerSelect a program Starting a program Remaining time Cleaning and care hintsAt the end of a program Before the end of a program Adding/removing laundry during a drying program Canceling a programCoin mechanism Continue drying Program guide Cool air Woollen handcareSmoothing Warm air Shirts JeansNormal, Hand iron Proofing Starting the timer function TimerSelect the submenu Timer Canceling the timer Selecting/Changing a Favorite FavoritesBasic menu Program Warm air, Cool air Drying level programsOther programs Saving a Favorite Low tempAssigning a direct select button Removing the lint filter Cleaning and CareCleaning the lint filter Disassembling the lint filter Clean the lint filters dry Clean the lint filters wet Cleaning the exterior and the control panel Inserting the lint filter Check and fault messages in the display Frequently asked questionsWhat if Possible cause Solution Program What if Possible cause Solution At the end of aAppears Other faults Drum? What if Possible fault Solution What if there isCondensed water Items made Be started, What if Possible cause Solution Program cannotStart indicator Display remains Changing the light bulb After sales service Optional accessories Installation Instructions Important Safety Instructions Save These Instructions Installation Front view Side view Rear view Top view Washer/ Dryer Stack Installation on a cement base Coin mechanism Transporting the dryer to the installation site InstallationLevel the dryer Electrical connection Installation of exhaust venting General notes How to calculate the effective duct length Tips about the ductwork Additional duct lengths 4 rigid pipe only Length Determining the position of the exhaust connection Changing the position of the exhaust connection Window connection Wall connection with rigid pipe Chimney connection Direct wall connection Dryer top view Collective exhaust duct Technical Data Disposal of the packing materials Caring for the environmentDisposal of an appliance Menu Settings To adjust standard settings Selecting Settings SettingsOpening the menu Settings Leaving the Settings menu Off LanguageAnti-crease Time of day Normal Contrast/Brightness Not during current program default settingDelivery status 0 minutes normal cooling down phase Standby Settings Supervisor level Entering the code Sort languages Supervisor level Timer Language entry Drying levels Display the residual moisture as a percentage Cleaning the airways Cleaning the lint filtersNormal Factory default Light Cool air freePage Page Page All rights reserved Nr 975 240